Installation with the bathtublift "Komfort"

This figure shows the bathlift "Komfort" mounted with a high floor fixing bracket.
In this figure, the seating belt is fed in in the basic device. The bathtub is free and can be used by other family members.

The belt is fed out from the basic device (1) by the touch of a button and clipped to the floor fixing bracket(2.1). Now the belt is tightened by touching the "Up" button. The figure above shows a wall lift (1) in combination with a high floor fixing bracket (2.1), which is used to fix the belt on the other side of the bathtub.

The figure in the middle shows a bathtublift in combination with a low floor fixing bracket (2.2).

Finally, the bottom drawing shows the principle with a side holder (2.3). This is attached to the side of the bathtub on the masonry and is practical because, unlike the flat bottom holder, you do not have to bend down so low to hang the towel.
Please note that this variant of the seat towel holder is not compatible with all bathtubs. If in doubt, please ask your dealer for advice.

This figure shows the bathlift ready for use. Now place yourself on the tub rim and slip to the middle of the belt. The belt is tightend by the basic device and grants you safe stability.

With the aid of the button "Down" on the device or the remote control, the belt lowers you gently and gradually down into the water.

The bathlift lowers you down safe and secure to the bottom of the tub. Now the belt is on the very bottom and you barely notice it.

 Now you can enjoy a relaxing and soothing bath!

When you have finished your bath, touch the button "Up" and you will be raised up.
Now you can get out of the tub in comfort. Touch the button "down" for a short moment, the belt loosens and you can take it out of the bracket and with the button "up" it will be fed in into the basic device so that it is clean and ranged.